M-1004 10" Subwoofer
- 10" Single 4-Ohm Subwoofer
- 325 watt RMS/650 Watts Max
- Proprietary DDC Coated Non-Pressed Paper Cone
- Large Roll Santoprene® Surround
- 2" Vented BASV Voice Coil Former
- Perimeter Aero-Vent Voice Coil Cooling Vents
- Non Resonance DDC Coated Stamped Steel Basket
- Rubber Mounting Gasket/Trim Ring
- Chrome Push Terminals
- Optimally Designed for Both Small Sealed or Ported Enclosures
M-1004 10" SUBWOOFER
The Mighty M Series Subwoofer is what most call the standard to real old school car audio subwoofers with its non pressed paper cone and big motor structure as well as it large bass sound the M is the best all around subwoofer for every type of enclosure.
Check out these other features: 4-layer non pressed paper DDC (Dynamic Damping Coating) finished cone, Large Roll Santoprene® surrounds which allow free movement of the cone for maximum SPL, a large motor structure for high-power handling, 2” and 2.5” vented BASV Voice Coil formers for optimum performance, and cooling for maximum heat dissipation.
For increased operating efficiency, a CNC machined one piece backplate and pole plate are used to reduce gause (magnetic) losses and maximize air flow keeping the voice coil running cooler.
Chrome-plated binding post terminals accept large gauge wire to insure all power from the amplifier reaches the subwoofer.
Specifications
- Nominal Impedance: Single 4-ohm
- BL: 13.1
- Inputs: Single Coil
- Subwoofer Frequency Range: 35 Hz - 500 Hz
- Voice Coil Size: 2 in
- Material: Non Pressed Paper
- Sensitivity (1W / 1M): 91 dB
- Motor Structure: 164 oz
- Cutout Diameter: 9 1/8" (230.1mm)
- Mounting Depth: 5.125 in
- Xmax: 9.0 mm
- Spl: 91 dB
- No: 0.31%
- Qts: 0.383
- Qes: 0.423
- Qms: 4.05
- Mms: 102.2 g
- Cms: 198.6 uM/N
- Vas: 30.75 Ltr
- SD: 330.06 sqCM
- Fs: 35 Hz
- Test Impedance: 3.2-ohms
- VC Impedance: 4-ohm
- Size: 10 in
- Sensitivity: 91 dB
- Frequency Response: 35 Hz - 500 Hz
- Voice Coil Size: 2 in
- Power Handling (RMS/Peak): 325 / 650 watts
Downloads
M-1004 10" Subwoofer
Other Views
Recommended Products
IN STOCK NOW!
- Extruded Aluminum Casing
- Built-in Rechargeable Li-ion Battery 1900mAH
- Micro USB 5V Charging
- Enhanced Ported Bass Response
- 3.5mm Aux input
- Single 10" 175 Watt RMS Amplified Downfiring Enclosure
- Computer Optimized 10" Thin Subwoofer Enclosure
- Custom Injected Molded Cone
- Large Roll Rubber Surround
- 2" Vented KSV Voice Coil Former
- Perimeter Aero Voice Coil Venting
- Poly-carbonate/Glass Fiber Composite Turbine Basket
- Chrome Push Terminals
- 2-Tone Vinyl/Carpet Finish
- 1-Channel 275 Watt High Efficiency Class A/B Design
- High Level (Speaker)/Low Level RCA input
- Soft Delay Turn On/Off Circuit
- Auto Turn-on (high level input only)
- Variable Low Pass Electronic Crossover 50Hz - 200Hz
- Variable 12db Bass Boost EQ @ 45Hz
- Variable Gain Control
- Protection Circuit: Impedance Over-load, Speaker Short Circuit, Thermal Overheating, and DC Output
- Wired Remote Gain Control Included
- Down Firing Air Suspension Enclosure
- Heavy-Duty Reinforced Box Design
- Mounting Hardware Included
- 4-Band Dual Zone Active Equalizer Bass, Mid-Bass, Mid, High
- 3 Zone Volume Control and Output
- Variable Master Volume Control
- Front Panel Selectable Inputs - Bluetooth, Aux, RCA
- Front Panel Tri Illumination Selector - Red, Blue, Green
- Front Panel Track Selector - Track Up / Down
- 6V RMS output
- Bi-Polar PWM Power Supply
- Frequency Response: 20Hz-40KHz
- Selectable 120/80Hz Subwoofer Crossover
- Conformal Coated PCB
IN STOCK NOW!
- 12 Speaker 500 watt Amplified Bluetooth Powersports Soundbar
- IPX6 Rated
- 6 x 3.5" Square Poly Cone Woofers
- 2 x 3” Full Range Marine Grade Poly Cone Speakers
- 4 x 1” SD Mylar Tweeters
- Heavy Duty Extruded Aluminum Water Tight Housing
- LED back-lit Control Panel
- LED Visual Notifications
- Audible Power On/Off Notifications
- Built In DSP Processor w/Distortion Limiter
- Bluetooth and Wired Inputs
- 2 Volt Line Output
- Auto Turn On/Off Circuit
- Waterproof Wire Loom Connectors
- Universal L-Bracket Mounting System Included
- Universal Top or Bottom Mount Clamp Style Brackets (Sold Separately XL-SBCLAMP, XL-SBTCLAMP, XL-SBSCLAMP)
- Secondary Dash Mountable Controller Pad (Sold Separately XL-SBCON)
- CRS 4.0 Bluetooth Protocol
- >30' Bluetooth Range
- RCA Audio Output
- Power, Track Up/Down & Volume Up/Down
- USB 5V Charging Port
- 12V Remote Amplifier Turn On/Off Lead
- Detente buttons for easy use with gloves
- Water resistant cables and connectors
- Surface or Flush Mount
- 800 Watt High Efficiency Class D Design
- 1-OHM Stable Mono Block Amplifier
- Ultra Low Current Draw
- Double Sided Copper Plated PCB
- PWM MOSFET Power Supply
- Digital Sound Optimization Circuitry
- High Damping Control Circuit
- Variable Subsonic Filter
- High Current Voltage Ripple Rejection Circuitry
- Balanced RCA Inputs
- Auto Turn On/Off
- Remote Soft Delay Turn On/Off Circuit
- 40 Click Variable Low Pass Electronic Crossover
- 40 Click Variable Frequency/18dB Bass Boost EQ
- Variable Gain Control
- Wired Secondary Remote Gain Control Included
- Protection Circuit: Impedance Over-load, Speaker Short, Circuit, Thermal Overheating, and DC Output
- Strapable Dual Amp Power Doubling Circuit (Amp-to-Amp Bridged at 2 ohm minimum)